Ultrasonic rubber cutting equipment
Equipment introduction:
This equipment can minimize the friction between materials and the damage to various industrial products, such as synthetic resin products, rubber products, non-woven fabrics, films, composite products, etc., which are difficult to cut through the high-speed micro vibration of blade 20000 ~ 40000 times per second (20khz-40khz / sec). It can be used for manual operation and can also be installed on automatic equipment.
What is the principle
The principle of ultrasonic cutting is completely different from traditional cutting. It uses the energy of ultrasonic to heat and melt all parts of cutting materials, so as to achieve the purpose of cutting materials. Therefore, the ultrasonic cutting does not need a sharp cutting edge, nor does it need a lot of pressure, so it will not cause the edge collapse and damage of the cutting material.
What are the disadvantages of traditional cutting
Traditional cutting is to cut the material into a sharp edge. The pressure is concentrated on the edge, the pressure is great. If the shear strength of the material to be cut is exceeded, the molecular bond of the material will be pulled apart and cut off. As the material is pulled hard under strong pressure, the tool blade should be very sharp, and the material itself should bear more pressure. The cutting effect of soft elastic material is not good, and the cutting of viscous material is more difficult.
Why ultrasonic cutting
1. High speed, high efficiency, no pollution.
2. Less friction, improve the efficiency of cutting operation.
3. Ensure that the incision is neat, smooth, no deformation, improve the appearance and value of the product.
4. Continuous cutting can be maintained to further improve production efficiency.
5. It can easily cut materials or products that are difficult to cut by ordinary cutting methods.
6. Simple operation: open the switch to cut.
7. Small size, installation does not need special equipment.
8. It is easy to be used in automatic production.
Application:
Ultrasonic rubber cutting equipment is often used to cut difficult to cut materials, such as thermoplastic resin board, sheet, film and laminated materials, carbon fiber composites, fabrics and rubber.